Axient Space

Axient is seeking several Electrical Engineer (Robotics ) to support the development, design, test, and manufacturing of electronic   Motion Control   products and systems. You will be a part of a multi-disciplinary project team collaborating on multi-board designs through development, and eventually transitioning a flight-ready product to the manufacturing and test engineering teams.
Bachelor's degree from an accredited technical college or university in Electrical or Computer Engineering and 3+ years of relevant work experience Experience with embedded system design, including: Schematic Capture and   PCB Layout, Digital, Analog , and Mixed Signal Design Board-level communication interfaces (I2C, SPI, UART, RS-232, RS-422, RS-485, CAN) Controlled impedance for high-speed channel design (SpaceWire, 10GbE, SerDes) Linear and Switch Mode DC/DC Power Conversion Documentation (Test Procedures & Reports, Interface Control Documents, ECOs) Design Analysis and Simulation (WCA/WCCA, Reliability, Radiation, Spice) Cable and Wire Harness Design Signal and Power Integrity (SI/PI) Electromagnetic Compatibility (EMC) Extensive experience in prototype development, debug, and test in a lab environment Demonstrable experience designing and launching products in regulated environments Preferred Qualifications: Experience designing motion control and electromechanical systems for harsh space environments Experience with: EEE-INST-002 and radiation-hardness/mitigation Failure Modes and Effects Analysis (FMEA) Generation of technical proposal content and labor/cost estimation Altium Designer BS degree in STEM Familiarity with: DSP and Microcontroller firmware development in C FPGA Design (Verilog and VHDL) System and functional requirements generation #CJ